Here is the user manual of Universal Magic Hand Saw by WAYPRO, This article show you how to use the Magic Hand Saw, The structure of Magic Saw and the application of each saw blade.
■ Application of Each Blade
- Steel Saw Blade: For General & Wood, Plastic, Rubber, Bamboo, Rope, Soft Metal, Stainless Steel, etc.
- Flat Saw Blade: For Large Three Plywood, Wood & PVC.
- Diamond Saw Blade: For Tile, Ceramic, Stone, etc.
- Diamond Grind Blade: Sharpening for Knife, Scissors, Glass, etc.
- Tile Drill Tip: For Tile, Glass, etc.
- Screw: Big Flat Saw Blade Screws.
■ Application of Flat-saw blade
■ How to Use the Drill?
- Loosen the nut and remove the coping saw blade.
- Remove the stainless steel frame from the handgrip.
- Install the drill tip on the port.
■ Description of Magic Hand Saw
Universal Hand Saw is a light compact hand-saw that lets you cut almost any material in both straight-line or and in curved-line. It’s an Essential for all toolboxes.
■ Cutting Straight or Cutting into Shape?
- Cutting Straight – Installation to the bottom groove
- Cutting into Shape, Curve or Cicle
- Left-handed – Installation to the right-side groove
- Right-handed – Installation to the left-side groove
■ How to Install Steel Saw Blade
- A blade should be assembled as above direction for pulling-way cutting, and vice versa for pushing-way cutting.
(Caution: If the blade is assemble in a different direction from user’s intention, it may not work effectively.) - Tighten the nut as much as possible to make the blade in firm condition. Place the roller onto the non-metal floor and tighten the nut with pressing the handgrip.
(Caution: Loosen the nut after using the magic saw to protect the blade.) - Gripping magic saw handle. See the photo on the right.
■ How to install Flat Saw Blade
- Loosen the nut and remove the coping saw blade.
- Remove the stainless steel frame from the handgrip.
- Insert the blade into the handgrip with pressing the spring pin of the flat saw.
- Removal: Pull the flat saw out of the handgrip with pushing the spring pin.
■ Glass or Tile Cutting Procedure
- Maintain the magic saw 45°from the cutting meterial, and drag the tungsten roller blade firmly from one end to the other end of the material surface to create a cutting line.
- Place a nail or electric wire under the material to be matched with cutting line.
Press the material with both gloved hands to snap it. - Snap the material with inserting it to the plier according to its gap size.
